Set the status of this timeseries. Possible values are 'use', 'validate', and 'ignore'. Specify the observational error standard deviation of this timeseries, that is independent of the value of the observations. The value is given in the same units as the observations. Specify the part of the observational error standard deviation that is proportional to the observed value. A value of 0.1 adds an error of 10percent to the standard deviation. The errors remain additive. Quantity being observed, e.g. waterlevel, etc. Unit of measurement in which the timeseries data is written. Source of data. Timezone in which data is written. Identity of the observation. Name of observing station. Coordinate of the position of the observing station. Minimum value for observation selection. Maximum value for observation selection. Begin time for observation selection. End time for observation selection Configuration of NOOS type observer. The observation data is available in different file for different observing location. Here the available observation files are listed. The properties of each file are by default read directly from the files, except 'status' and 'standardDeviation'. The properties can be overwritten by specifying the relevant attributes of the timeSeries element in this xml file. Sequence of observed data timeseries. Specify the file name of the NOOS data timeseries. The path is written relative to the directory where this xml file is stored.